CCNA Exam Prep Question of the Week

You want to configure IPv6 and RIPng on your router’s interface FastEthernet 0/0. Which configuration accomplishes this?

  1. interface fa0/0
    ipv6 address 2003:1A2B::/64 eui-64
    ipv6 rip NEW enable
  2. ipv6 unicast-routing
    interface fa0/0
    ipv6 address 2003:1A2B::/64 eui-64
    ipv6 router rip NEW
    network 2003:1A2B::/64
  3. interface fa0/0
    ipv6 address 2003:1A2B::/64 eui-64
    ipv6 router rip NEW
    network 2003:1A2B::/64
  4. ipv6 unicast-routing
    interface fa0/0
    ipv6 address 2003:1A2B::/64 eui-64
    ipv6 rip NEW enable

 

The correct answer is 4.

The “ipv6 unicast-routing” command is needed before configuring an IPv6 routing protocol. The routing protocol is enabled at the interface level, not in router configuration mode. The “ipv6 rip NEW enable” command enables the RIPng process called NEW on the interface.

Resources:
CCNA Cert Check
CCNA Exam Prep Mobile App

Related Courses:
ICND1 — Interconnecting Cisco Network Devices 1
ICND2 — Interconnecting Cisco Network Devices 2
CCNAX — CCNA Boot Camp v1.1

In this article

Join the Conversation